Instruction manual

5. Operations Required for Initial Installation
78
5.1 Notes before installing a Switch
The following must be done when installing a Switch.
(1) Checking the progress of Switch startup
The progress of the Switch from the time the power is turned on until the Switch has
started is tracked as follows:
 After the power is turned on, the ST1 LED on the front panel begins blinking
green, and the boot process starts.
 After the Switch has completely started, the ST1 LED turns green.
(2) Remove the memory card before starting the Switch
Memory cards are used in the following situations:
 Saving error information in the event of a failure.
 Updating software.
For further information on inserting and removing the memory card, see
4.5 Inserting
and removing memory cards.