Instruction manual

4. Installing Components and Adding, Replacing, or Removing Switches

4.8 Connecting interface cables

(1) UTP cable

Insert the connector until you hear a click.

Figure 4-15 Attaching the UTP cable

(1) UTP cable

For detaching the cable, pull out the connector with the tab held down.

For a PoE connection, if you disconnect and then re-connect a UTP cable within two

seconds of connecting the cable, the power class of the equipment on the

power-receiving side might not be recognized correctly.

Wait for more than two seconds before attaching the cable again.

(2) Optical fiber cable (LC duplex connector)

Insert the connector until you hear a click.

Figure 4-16 Optical fiber cable (LC duplex connector)

(1) Optical fiber cable (LC duplex connector)

(2) Transceiver