Instruction manual

4. Installing Components and Adding, Replacing, or Removing Switches
67
4.4 Connecting and disconnecting a power cable to and from
the main device
This section describes how to connect and disconnect a power cable to and from the
main device.
Follow the procedures below to connect or disconnect the power cable.
4.4.1 AC power cable
Always use a grounded outlet. Failure to do so might not only result in electric shock,
but it might also introduce unwanted electrical noise that could cause a Switch
failure.
When a switch is installed in a rack, use the cable holder supplied with the rack to fix
the power cable in order to prevent stress on the cable base.
(1) Installing
[Step 1]
Connect the supplied power cable to the AC power connector on the rear of
the Switch.
Figure 4-6 Attaching the power cable
(1) Cable clamp
(2) AC power cable
(3) AC power connector
When using an AX2200S- or AX1250S-series switch in a 100 VAC environment, use
the supplied power cable or an optional cable available from ALAXALA.
Using another cable could result in fire or electric shock.
In addition, do not use the supplied power cable with another switch.
Doing so could result in a fire or electric shock.
The AC power supply cable included with the AX1240S series is for use only with
the Switch. It cannot be used with any other device. Using the power cable with
another device is very dangerous and could result in fire or electric shock.