Instruction manual

4. Installing Components and Adding, Replacing, or Removing Switches

4.3 Installation of the main device

This section describes the way to install the device on a table or a rack. Follow the

procedures below.

4.3.1 Table mount

This device can be installed on the level, stable, flat surface. The installation

procedures are as follows:

[Step 1]

Flip the EPU upside down on a flat surface.

[Step 2]

Attach the four rubber pads within the marks on the bottom of the EPU.

Figure 4-1 Attaching the rubber pads

(1) Rubber pad

(2) Mark

Confirm that the position to attach the rubber pad has no dirt. Wipe any dirt off with a

dry cloth before attaching the rubber pad.

[Step 3]

Flip the EPU back over and mount it on the table.

4.3.2 Rack mount

This device can be installed into a 19-inch cabinet rack conforming to the EIA

standard. The procedure is as follows:

The supplied rack mounting brackets are designed for M5 screws. Prepare a rack

that accommodates M5 screws.

For rack-mounting conditions, see

2.7 Installation location (2) 19-inch cabinet rack.