Instruction manual

3. Preparation of Interface Cables and Terminals
54
3.1 Connecting interface cables and terminals
The applicable interfaces for the Switch and the cables to connect to the interfaces are
listed in
Table 3-1 Interface cables and terminal connection cables.
The user should provide these cables.
Table 3-1 Interface cables and terminal connection cables
Port/Slot Transceiver Interface Cable Connector
10/100BASE-TX port
(PoE not supported)
-
10BASE-T UTP cable
(Category 3 or higher)
RJ45
Connector
100BASE-TX UTP cable
(Category 5 or higher)
10/100BASE-TX port
(PoE supported)
-
10BASE-T UTP cable
(Category 5 or higher)
#1
100BASE-TX UTP cable
(Category 5 or higher)
10/100/1000BASE-T
port
(PoE not supported)
-
10BASE-T UTP cable
(Category 3 or higher)
100BASE-TX UTP cable
(Category 5 or higher)
1000BASE-T UTP cable
(Enhanced Category 5 or
higher)
10/100/1000BASE-T
port
(PoE supported)
-
10BASE-T UTP cable
(Category 5 or higher)
100BASE-TX UTP cable
(Category 5 or higher)
1000BASE-T UTP cable
(Enhanced Category 5 or
higher)
#2
SFP slot SFP-FX 100BASE-FX Multiple-terminal mode optical
fiber
(core/cladding diameter = 50
µm/125 µm)
LC2 core
Connector
Multiple-terminal mode optical
fiber
(core/cladding diameter = 62.5
µm/125 µm)
SFP-SX 1000BASE-SX Multiple-terminal mode optical
fiber
(core/cladding diameter = 50
µm/125 µm)