Instruction manual

1. Components Overview
5
No. Name Type Description Details
(5) ACC LED: Green Indicates the
memory card
status.
Lit: Accessing the memory card. (Do not remove the
memory card.)
Off: Memory card is in idle mode. (The memory card
can be inserted or removed.)
(6) CONSOLE Connector CONSOLE port RS-232C port to connect a console terminal
(7) LINK / T/R LED: Green Indicates the
operating status
of an SFP slot
Ethernet port.
Lit in green: Initial state after the switch is turned on,
or when a link is established.
Blinking green: Sending or receiving frames.
Off: Link failure or block when the green ST1 LED is
on#4
(8) 1-24 LED: Green Indicates the
operating status
of a
10/100/1000BA
SE-T Ethernet
port.
Lit in green: Initial state after the switch is turned on,
or when a link is established.
Blinking green: A link is established and frames are
being sent or received.
Off: Link failure or block when the green ST1 LED is
on#4
(9) RESET Button
(non-locking)
Manual RESET
button of the
device
#1
Restarts the device.
#1: The switch is behind the front panel. Use a screwdriver with a small head to
press the button.
When pressing the RESET button, do not use anything with a fragile tip, or anything
that might become caught in the Switch, such as a pin or paper clip. Doing so could
result in a fire or electric shock.
1.1.2 AX2230S-24P
The AX2230S-24P model has the following hardware specifications:
 Ethernet 10/100/1000BASE-T ports: (PoE supported): 24
 SFP slots: 4
 Memory card slot: 1
 CONSOLE port: 1
The Alternative A and Alternative A+B PoE systems are used for the switch. For
details, see
3.2.2 Ethernet 10/100/1000BASE-T.
For information about the SFPs supported by the Switch, see
1.3.1 SFP.