Instruction manual

1. Components Overview
2
1.1 Main device
The AX2200S-series switches consist of Gigabit Ethernet Layer-2 switches that can
be used as floor switches for local area networks, or as workgroup switches.
The AX1250S and AX1240S series switches provide Layer 2 Fast Ethernet
switching and can be used as workgroup switches or as floor edge switches for local
area networks.
The following models belong to the AS2200S, AX1250S, and AX1240S series.
Table 1-1 AX2200S, AX1250S, and AX1240S series switch models
No.
LAN interface
Model
10/100/1000
BASE-T
10/100/1000B
ASE-T (PoE)
10/100BAS
E-TX
10/100BASE-TX
(PoE)
SFP slot
1 24 port -- -- -- 4 slots AX2230S-24T
(AC model)
2 -- 24 port -- -- 4 slots AX2230S-24P
(AC model)
3 2 port -- 24 port -- 2 slots AX1250S-24T2C
(AC model)
AX1240S-24T2C
(AC model)
4 2 port -- -- 24 port 2 slots AX1240S-24P2C
(AC model)
5 2 port -- 48 port -- 2 slots AX1240S-48T2C
(AC model)
Ports 25 to 26 of models AX1250S-24T2C, AX1240S-24T2C, and AX1240S-24P2C, and
ports 49 to 50 of model AX1240S-48T2C are shared by SFP slots and
10/100/1000BASE-T. These ports cannot be assigned to both SFP and
10/100/1000BASE-T at the same time. Configure each port as an SFP slot or as a
10/100/1000BASE-T port. (Ports 25 to 26 of models AX1250S-24T2C, AX1240S-24T2C,
and AX1240S-24P2C, and ports 49 to 50 of model AX1240S-48T2C are configured as
SFP slots by default.)
For details about editing the configuration, see the Software Manual.
The Switch contains a flash memory storage device to store software, configuration
data, and log information. The number of times the memory can be written to is
limited and should be noted during operation. For detailed notes about writing data
to a flash disk, see 10 Switch Management in the Software Manual Configuration
Guide Vol. 1.