Instruction manual

Appendix C Specifications of setup terminal
98
C. Specifications of setup terminal
C.1 Specifications of setup terminal
Use a personal computer or a workstation that meets the specifications listed
in
Table C-1.
Table C-1 Specifications of the terminal
Item Specification
Communication port RS-232C port
Communication software
Tera Term Pro (Version 2.3) or communication software that supports the
following communication settings.
Operation mode VT100 emulation mode
Communication
settings
Communication
parameters
8 bits, 1 stop bit, no parity
Communication
speed
19,200 bit/s, 9,600 bit/s, 4,800 bit/s, 2,400 bit/s, 1,200 bit/s
#1: The factory default communication speed of the Switch is 9,600 bit/s.
C.2 Specifications of cable to connect setup terminal
The RS-232C crossover cable of inch screws (#4-40) with D-sub 9-pin female
connectors on both ends is required for connection between the main device and the
setup terminal. For pin assignment of the RS-232C crossover cable, see
Table
C-1
Figure C-1 Pin assignment of the cable to connect the setup terminal.
Figure C-1 Pin assignment of the cable to connect the setup terminal