Instruction manual

5. Operations Required for Initial Installation
82
New username:
ax12-01 Type the new user ID.
# password
Enable the login password setting.
Changing the local password for ax12-01. The login user ID is displayed (in this case, ax12-01).
New password: ********** Set a login password.
Retype new password: ********** Re-type the password for confirmation.
#
Login user IDs can be between 1 and 8 characters.
Up to between six and 16 characters can be entered for the password. (If a
password longer than 16 characters is entered, only the first 16 characters are
registered.)
A password cannot contain only lowercase letters. We recommend using a
combination of uppercase letters, numbers, and special characters.
(d) Setting the time
Set the time zone and the time. The following example shows the procedure for
setting the time zone as "Japan" and the time to "February 22, 2011, 15:30".
# configure
Enter configuration command mode.
(config)# clock timezone JST +9
Set the time zone to JST, which is a +9 hour-offset from UTC.
!(config)# save
Save the time zone setting.
(config)# exit
Return to administrator mode.
# set clock 1102221530
Enter a date and time as a set of two-digit values (in
year-month-day-hour-minute).
Tue Feb 22 15:30:00 JST 2011
#
When the configuration is modified, ! is displayed at the prompt. After the
configuration is saved, ! is no longer displayed.
The time setting for the Switch is retained for about ten days after being shut down.
After more than ten days, the clock needs to be reset when the device is turned on
the next time.