Specifications

show ntp-client
71
Item Displayed information Displayed information
Mode NTP client acquisition mode Unicast, Multicast, Broadcast, or
Command
Lapsed time The amount of time that has elapsed since
the time was obtained from the NTP server
From 0 to 4294967295 (seconds)
Offset Time lag with the NTP server The range of values is from -2147483648 to
2147483647 (seconds).
Activate NTP
Client
Information about the mode of the currently
operating NTP client
--
NTP-Server NTP server address This item is displayed only in unicast mode.
Source-Address The specified source IP address This item is displayed in unicast mode, but
--- is always displayed because the source
IP address is not specified.
Mode NTP client acquisition mode Unicast, Multicast, or Broadcast
Interval The value registered by using the ntp
interval command
If nothing is registered, 3600 is displayed by
default.
This item is displayed only in unicast mode.
The range of values is from 120 to 604800
(seconds).
NTP Execute
History(Max 10
entry)
History information on the executed NTP
client operations
A maximum of 10 histories, which are the
latest, are displayed.
NTP-Server NTP server address Unicast: Values set by configuration
Multicast, Broadcast: NTP server
address of the acquisition source
Command:--- is displayed if the command
has not been configured.
Source-Address The specified source IP address This item is displayed in unicast mode, but
--- is always displayed because the source
IP address is not specified.
Mode NTP client acquisition mode Unicast, Multicast, Broadcast, or
Command
Set-NTP-Time Set NTP time If a timeout occurs or if the time cannot be
acquired, the current time on the Switch is
displayed.
Status Offset value or status Offset value: From -2147483648 to
2147483647 (seconds)
If the time has been obtained normally, the
offset value is displayed. For all other cases,
see Status display
#1
.