Specifications

l2traceroute
601
Message Description
No such Remote MEP. The specified remote MEP is unknown. Make sure the
specified parameter is correct, and then try again.
Specified Domain Level is not configured. The specified domain level has not been configured.
Make sure the specified parameter is correct, and then
try again.
Specified MA is not configured. The specified MA ID number or the primary VLAN for the
specified MA has not been configured. Make sure the
specified parameter is correct, and then try again.
Specified MEP is not configured. The specified MEP ID has not been configured. Make
sure the specified parameter is correct, and then try
again.
Notes
 To halt execution of this command, press Ctrl + C.
 This command cannot be used concurrently by multiple users. (This command also
cannot be used concurrently with the
l2ping command.)
 If you execute this command multiple times for the same remote MP, only the last
execution result is retained in the linktrace database.
 Information about some replies is not displayed if those replies are received after
being forwarded by a number of devices that exceeds the number of devices on the
routes that can be registered in the linktrace database.
 The MAC address of the remote MP is used to verify the route. Even when
remote-mep is specified, the route is verified by using the MAC address that
corresponds to the MEP ID. Therefore, even when the specified MEP ID does not
exist, due to a configuration change or another reason, a reply is sent if an MEP or
MIP has that MAC address.
 We recommend that you specify 64 or less for the TTL value to maintain the
reception performance of the Switch.