Specifications

l2ping
598
Item Meaning Displayed information
Lost Frame Percentage of lost frames
(%)
--
Round-trip Min/Avg/Max Minimum, average, and
maximum response time
--
Impact on communication
None
Response messages
Table 35-2 List of response messages for the l2ping command
Message Description
Can't execute. The command could not be executed. Re-execute the
command.
CFM is not configured. CFM has not been configured. Check the configuration.
No such Remote MEP. The specified remote MEP is unknown. Make sure the
specified parameter is correct, and then try again.
Specified Domain Level is not configured. The specified domain level has not been configured.
Make sure the specified parameter is correct, and then
try again.
Specified MA is not configured. The specified MA ID number or the primary VLAN for the
specified MA has not been configured. Make sure the
specified parameter is correct, and then try again.
Specified MEP is not configured. The specified MEP ID has not been configured. Make
sure the specified parameter is correct, and then try
again.
Notes
 To halt execution of this command, press Ctrl + C.
 This command cannot be used concurrently by multiple users. (This command also
cannot be used concurrently with the
l2traceroute command.)
 If you want to specify 1476 bytes or more for the
framesize parameter, use the mtu
or
system mtu configuration command to set the MTU value for the jumbo frame to
1500 byte or more.
 To verify connectivity, use the MAC address for the remote MP. Even when
remote-mep is specified, the connectivity is verified by using the MAC address that
corresponds to the MEP ID. Therefore, even when the specified MEP ID does not
exist, due to a configuration change or another reason, a reply is sent if an MEP or
MIP has that MAC address.