Specifications

wol [OP-WOL]
543
wol [OP-WOL]
Directly sends the startup command to the specified terminal to turn it on.
Syntax
wol <MAC> <VLAN ID>
Input mode
Administrator mode
Parameters
<MAC>
Specify the MAC address of the terminal to which the startup command is to be sent.
Specify the MAC address in the range from
0000.0000.0000 to feff.ffff.ffff.
Note that you cannot specify a multicast MAC address (address in which the lowest
bit of the first byte is 1).
<VLAN ID>
Specify the VLAN ID of the VLAN to which the terminal to which the startup
command is to be sent belongs. For details about the specifiable range of values,
see Specifiable values for parameters.
Example
Sending the startup command to the terminal whose MAC address is 0012.e256.7890 and
VLAN ID is
200:
# wol 0012.e256.7890 200
Display items
None
Impact on communication
None
Response messages
Table 29-24 List of response messages for the wol command
Message Description
The magic packet is sent. The startup command has been sent.
The magic packet is not sent. An attempt to send the startup command failed.
License key is not installed. The Secure Wake-on-LAN software option license key has
not been set.
Notes
 This command can be executed only after the software option license key has been
installed.
 One execution of this command will send the startup command only once.