Specifications

copy
36
Message Description
Can't access to MC by write
protection.
Make sure the memory card's protect switch is not set to Lock. If the
switch is set to Lock, move it to the opposite side, and then insert the
memory card again.
Make sure there is no dust in the memory card slot. If there is dust,
remove it with a dry cloth and then insert the memory card again.
Can't copy subdirectory. Subdirectories cannot be copied.
File name length exceeds the limit. The file name or the directory, including its path name, exceeds 64
characters.
MC is not inserted. A memory card was not inserted.
Not enough space on device. Capacity at the write destination is insufficient.
Source and destination are identical. The source and destination files for a transfer exist at the same location.
Notes
 Editing the startup configuration file has no effect on the running configuration or
communication.
 If a file on the RAMDISK is copied to the startup configuration file, you must restart
the device to apply the file to the running configuration. Restart the device by
executing the
reload command, or by turning it off and then on again.
 If the copy destination is the startup configuration file, the copy processing is
performed even if there is an error in the specified configuration file. After the device
is restarted, execute the
show logging command to make sure the operation log
does not indicate an inconsistent configuration.
 If there is insufficient free space for storing files, a configuration cannot be copied.
Use the
show mc command and the show ramdisk command to check the unused
capacity. The necessary space required for copying a configuration is the total size
of the new configuration in the copy source and the existing configuration in the copy
destination. About 1MB of free capacity is required for a maximum-size configuration
file.
 If a file on the memory card is specified, the command can be executed only when
the memory card is inserted.
 If a file on the memory card is specified, the ACC LED on the device is on while the
command is being executed. Do not remove or insert the memory card while the
ACC LED is on.
 Note that the file copied to the RAMDISK will be deleted when the device restarts.
 Specify the file name with 64 or fewer characters. If the file name is too long, it will
not be displayed correctly when the
show mc-file or show ramdisk-file command
is executed.
 If you create the configuration file on your PC and save it to the memory card used
for operation, specify the file name with 64 or fewer characters.
 You cannot view the
auto-log file because it is a binary file that the manufacturer
uses for failure analysis.
 If the source and destination files for a copy operation are the same, an error occurs
as follows:
When both the copy source and the copy destination are the memory card and the