Specifications

set wol-authentication user [OP-WOL]
526
Response messages
Table 29-14 List of response messages for the set wol-authentication user command
Message Description
Already user '<User name>' exists.
The specified user has already been registered.
The number of users exceeds 300. The number of users to be registered exceeds 300.
The sum of the device of each user exceeds 300. The number of combinations of users and terminals set for
each user has exceeded 300.
License key is not installed. The Secure Wake-on-LAN software option license key has
not been set.
Notes
 This command can be executed only after the software option license key has been
installed.
 To check user information, execute the
show wol-authentication user command.
 The maximum number of users that can be registered is 300.
 The upper limit on the number of combinations of users and terminals is 300. For
example, if you allowed one user to access 300 terminals, then no more access
permissions for other terminals can be set for the user. The
any and manual settings
are excluded from this limit.
 You can allow one user to access multiple terminals, but one execution of the
command only registers access permissions for one terminal. To allow access to
more terminals, use the
set wol-authentication permit command.
 This command applies only to the registration of a new user. To change the setting,
use another
set wol-authentication command.