Specifications

set wol-authentication user [OP-WOL]
525
set wol-authentication user [OP-WOL]
Registers new user information in the internal DB for user authentication. Specify the name
of an accessible terminal and access permissions.
To apply the setting to user information, execute the
commit wol-authentication
command.
Syntax
set wol-authentication user <User name> <Password> permit [any] [manual] [device-name
<Name>]
Input mode
Administrator mode
Parameters
<User name>
The user name.
Specify 1 to 128 characters. You can use alphanumeric characters (case sensitive),
at marks (
@), hyphens (-), underscores (_), and periods (.).
<Password>
Specify the user password.
Specify 1 to 32 characters. You can use alphanumeric characters (case sensitive), at
marks (
@), hyphens (-), underscores (_), and periods (.).
permit [any] [manual] [device-name <Name>]
any
Sets access permissions for all terminals that have been registered in the
internal DB used to register the terminal that sends the startup command.
manual
Sets access permissions that directly specify the MAC address and VLAN ID.
device-name <Name>
Sets the terminal name that has been registered in the internal DB used to
register the terminal that sends the startup command.
Specify 1 to 128 characters. You can use alphanumeric characters (case
sensitive), at marks (
@), hyphens (-), underscores (_), and periods (.).
Note on setting this parameter
You cannot omit all of the parameters. Specify at least one of the parameters.
Example
Registering the new user name USER01:
# set wol-authentication user USER01 pass permit any manual device-name PC01
Display items
None
Impact on communication
None