Specifications

load wol-device [OP-WOL]
523
load wol-device [OP-WOL]
Restores from a backup file the internal DB used to register the terminal that sends the
startup command.
Note that information registered or changed by using the following commands will be
replaced by the information that is being restored:

set wol-device name command

set wol-device mac command

set wol-device vlan command

set wol-device ip command

set wol-device alive command

set wol-device description command

remove wol-device name command

commit wol-device command
Syntax
load wol-device ramdisk <File name> [-f]
Input mode
Administrator mode
Parameters
ramdisk
Restores to the RAMDISK from a backup file the internal DB used to register the
terminal that sends the startup command.
<File name>
Specify the name of the file from which the internal DB for registering the
terminal that sends the startup command is to be restored.
Specify the file name with 64 or fewer characters. For the characters that can
be specified, see Specifiable values for parameters.
-f
Restores the internal DB used to register the terminal that sends the startup
command without displaying a confirmation message.
Operation when this parameter is omitted:
A confirmation message is displayed.
Example
Restore the internal DB used to register the terminal that sends the startup command from
the backup file:
# load wol-device ramdisk wol_dev.txt
Restore wol-device name data. Are you sure? (y/n): y
Restore complete.
#
Display items
None