Specifications

set wol-device name [OP-WOL]
504
set wol-device name [OP-WOL]
Registers information about a new terminal that sends the startup command for Secure
Wake-on-LAN. The information is registered in the internal DB used to register the terminal
that sends the startup command.
To apply the setting to the terminal information, execute the
commit wol-device
command.
Syntax
set wol-device name <Name> <MAC> <VLAN ID>[ip <IP address> ][ alive {check [timeout
<Seconds>] | nocheck} ][ description <Description> ]
Input mode
Administrator mode
Parameters
<Name>
Specify a terminal name.
Specify 1 to 128 characters. You can use alphanumeric characters (case sensitive),
at marks (
@), hyphens (-), underscores (_), and periods (.).
<MAC>
Specify the MAC address.
Specify the MAC address in the range from
0000.0000.0000 to feff.ffff.ffff.
Note that you cannot specify a multicast MAC address (address in which the lowest
bit of the first byte is 1).
<VLAN ID>
Specify the VLAN ID of the VLAN to which the terminal will belong. For details about
the specifiable range of values, see Specifiable values for parameters.
ip <IP address>
Directly specify the IP address of the terminal in a static IP address environment.
Specify the IP address in the range from
1.0.0.0 to 126.255.255.255 or from
128.0.0.0 to 223.255.255.255.
Operation when this parameter is omitted:
DHCP is used. In a DHCP environment, an IP address is set in conjunction
with DHCP snooping.
alive
Sets verification that the terminal is still activated.
check [timeout <Seconds>]
Verifies that the terminal is still activated.
timeout <Seconds>
Sets the interval for verifying terminal activation. Specify an interval from 60 to
600 seconds.
Operation when this parameter is omitted:
The verification interval is set to 120 seconds.
nocheck
Sets that verification of terminal activation is not performed.