Specifications

commit mac-authentication
492
commit mac-authentication
Stores the internal MAC-based authentication DB in internal flash memory and reflects its
contents for operation.
The contents of the internal MAC-based authentication DB which is being used is not
overwritten unless this command is executed after the following commands are executed to
add or delete MAC addresses:
 set mac-authentication mac-address
 remove mac-authentication mac-address
Syntax
commit mac-authentication [-f]
Input mode
Administrator mode
Parameters
-f
Stores the internal MAC-based authentication DB in internal flash memory and
reflects its contents for operation. No confirmation message is displayed.
Operation when this parameter is omitted:
A confirmation message is displayed.
Example
The following shows an example of storing the internal MAC-based authentication DB:
# commit mac-authentication
Commitment mac-authentication mac-address data. Are you sure? (y/n): y
Commit complete.
#
Display items
None
Impact on communication
None
Response messages
Table 27-24 List of response messages for the commit mac-authentication command
Message Description
Commit complete. Storing the DB in internal flash memory and reflecting its
contents for MAC-based authentication finished normally.
Flash memory write failed. Writing of the information to internal flash memory failed.
MAC-Authentication is not configured. The MAC-based authentication functionality is not
configured. Check the configuration.