Specifications

ftp
21
ftp
Transfers files between the Switch and a remote operation terminal connected via TCP/IP.
Syntax
ftp <IP address>
Input mode
User mode and administrator mode
Parameters
<IP address>
Specifies the IP address of the remote operation terminal.
Operation when this parameter is omitted:
This parameter cannot be omitted.
Example
Logs in to the remote operation terminal whose IP address is 192.168.0.1.
> ftp 192.168.0.1 Press the Enter key.
After the ftp command is executed, wait for the connection to the remote operation
terminal to be established. When the connection is established, the input prompt (see steps
1 and 2 below) is displayed. If a connection is not established, the mode returns to
operation command mode.
1. Entering the login name:
The following prompt is displayed on the command line. Enter the login name for the
remote operation terminal, and then press the Enter key.
Name:
2. Entering the password:
The following prompt is displayed on the command line. Enter the password for the
specified login name, and then press the Enter key.
Password:
3. Entering a file transfer command:
The following prompt is displayed on the command line.
ftp>
Enter a file transfer command according to the transfer direction, and then press the
Enter key.
The following table describes the parameters that can be specified for file transfer.
Parameter type Description Number of
characters
<Local file>
You can use alphanumeric characters, hyphens
(-), underscores (_), and periods (.).
See Base name under File name in Specifiable
values for parameters.
1 to 64 characters