Specifications

clear dot1x auth-state
353
Impact on communication
If initialization is performed, the IEEE 802.1X authentication status on the relevant ports or
VLANs is initialized, and communication is lost. To restore communication,
re-authentication is necessary.
Response messages
Table 25-6 List of response messages for the clear dot1x auth-state command
Message Description
Can't execute. The command could not be executed. Re-execute the command.
Dot1x doesn't seem to be
running.
The IEEE 802.1X setting has not been enabled. Check the configuration.
No operational Channel Group. There are no available channel groups. Check the authentication mode set
by the configuration.
No operational Port. There are no available ports. Check the authentication mode set by the
configuration.
No operational VLAN(Dynamic). VLAN-based authentication (dynamic) was not configured. Check the
authentication mode set by the configuration.
No authenticated user. The specified unit of authentication exists, but there is no authenticated user
registered.
Notes
When authentication status is initialized, EAP-Req/Id might be sent according to the
specified parameter.
 If the parameter is omitted, EAP-Req/Id is multicasted once to all units of IEEE
802.1X authentication in the device.
 If the parameter is
port <Port# list>, channel-group-number <Channel group# list>,
or
vlan dynamic, EAP-Req/Id is multicasted once to the specified unit of IEEE
802.1X authentication.
 If the parameter is
supplicant-mac <MAC>, and if there is no authentication
terminal under the IEEE 802.1X authentication to which the specified authentication
terminal belongs, EAP-Req/Id is multicasted once to the unit of IEEE 802.1X
authentication to which the specified authentication terminal belongs.