Specifications

show dot1x
350
Item Meaning Displayed information
SessionTime Displays the time (in seconds for each supplicant) required to establish a session
after a successful authentication.
Date/Time Displays the first time that authentication of the supplicant was successful.
SubState (For port-based authentication (static or
dynamic) only) This item displays the
authentication sub-status of the
supplicant.
Full: Full access is permitted
(when AuthState is
Authenticated)
Protection: Limited access is
permitted (when AuthState is
Authenticated)
# In multistep authentication, even if
the first step of terminal
authentication succeeds and user
authentication is being awaited in
the second step, Protection is
displayed.
---: There is no sub-status because
authentication is not complete
(AuthState is not
Authenticated.)
Impact on communication
None
Response messages
Table 25-4 List of response messages for the show dot1x command
Message Description
Can't execute. The command could not be executed. Re-execute the
command.
Dot1x doesn't seem to be running. The IEEE 802.1X setting has not been enabled. Check the
configuration.
No operational Channel Group. There are no available channel groups. Check the
authentication mode set by the configuration.
No operational Port. There are no available ports. Check the authentication
mode set by the configuration.
No operational VLAN(Dynamic). VLAN-based authentication (dynamic) was not configured.
Check the authentication mode set by the configuration.
Notes
Information about the supplicants for which VLAN dynamic assignment failed in
VLAN-based authentication (dynamic) is not displayed.