Specifications

show qos-flow
324
Response messages
Table 23-2 List of response messages for the show qos-flow command
Message Description
Can't execute. The command could not be executed. Re-execute the
command.
No configuration. No QoS flow group was set for the Ethernet interface or
VLAN interface. Make sure the specified parameter or
QoS flow group setting is correct, and then try again.
No such ID. No QoS flow group that is specified with the QoS flow list
name <QoS ID> was applied to the interface. Make sure
the specified parameter is correct, and then try again.
No such interface. The specified VLAN interface has not been configured.
Make sure the specified parameter is correct, and then
try again.
Notes
 Some packets are not supported by the QoS functionality, however they might be
counted only by the counter displayed by this command. For details, see 3. Flow
Control in the Configuration Guide Vol. 2.
 Packets with a reception error (such as an FCS error) are discarded, however they
might be counted on the counter displayed by this command.