Specifications

show access-filter
318
Item Displayed information
Detailed information Meaning
Statistics
matched packets:<packets>
Number of packets that meet the filter conditions in
the access list
implicitly denied packets:<packets>
Number of packets that were discarded because
they did not meet any of the filter conditions in the
access list
Impact on communication
None
Response messages
Table 22-2 List of response messages for the show access-filter command
Message Description
Can't execute. The command could not be executed. Re-execute the
command.
No configuration. No access group was set for the Ethernet interface or
VLAN interface. Make sure the specified parameter or
access-group setting is correct, and then try again.
No such ID. No access group was set for the access group for the
specified ID <ACL ID>. Make sure the specified
parameter is correct, and then try again.
No such interface. The specified VLAN interface has not been configured.
Make sure the specified parameter is correct, and then
try again.
Notes
 Some packets are not supported by the filtering functionality, however, they might be
counted only by the counter displayed by this command (including
deny). For details,
see 1. Filters in the Configuration Guide Vol. 2.
 Packets with a reception error (such as an FCS error) are discarded, however they
might be counted on the counter displayed by this command.