Specifications

activate power inline [AX2200S][AX1240S]
178
activate power inline [AX2200S][AX1240S]
Manually resumes the supply of power.
Syntax
activate power inline gigabitethernet <IF#> [AX2200S]
activate power inline fastethernet <IF#> [AX1240S]
Input mode
User mode and administrator mode
Parameters
gigabitethernet [AX2200S]
Specifies a 10BASE-T/100BASE-TX/1000BASE-T interface.
fastethernet [AX1240S]
Specify a 10BASE-T or 100BASE-TX interface.
<IF#>
Specify an interface port number. The specifiable values are from
0/1 to 0/24.
Example
> activate power inline fastethernet 0/5
Display items
None
Impact on communication
Yes
Response messages
Table 13-17 List of response messages for the activate power inline command
Message Description
This model does not support PoE. This model does not support PoE. Make sure the model
supports PoE.
<IF#> is disabled.
The command could not be executed because the port
was in the shutdown state or the port does not supply
power.
<IF#>:Interface port number
Notes
 This command is ignored if it is executed when the port is in the shutdown state.
 Power is not supplied if this command is executed for a port set by the
power inline
never configuration command.
 The
shutdown or no shutdown configuration command overwrites the status set by
this command. However, if the
shutdown or no shutdown configuration command
does not change the status, the status is not overwritten.