Specifications

show interfaces
146
Figure 13-4 Result of executing the command for displaying detailed information about the
1000BASE-T interface
> show interfaces gigabitethernet 0/26
Date 2008/11/17 13:13:17 UTC
Port 0/26 : active up 1000BASE-T full(auto) 00ed.f010.0132 <-1
Time-since-last-status-change: 00:00:10 
Bandwidth: 1000000kbps Average out: 0Mbps Average in: 1Mbps |
Peak out: 0Mbps at 00:00:00 Peak in: 1Mbps at 13:13:16 |
Output rate: 0bps 0pps |
Input rate: 501bps 1pps |2
Flow control send : off |
Flow control receive: off |
TPID: 8100 |
Frame size: 1518 Octets Interface name: gigaether0/26 |
Description: 
<Out octets/packets counter> <In octets/packets counter> 
Octets : 0 Octets : 153152|
All packets : 0 All packets : 2393|3
Multicast packets : 0 Multicast packets : 2393|
Broadcast packets : 0 Broadcast packets : 0|
Pause packets : 0 Pause packets : 0
<Out line error counter> 
Late collision : 0 Defer indication : 0|
Single collision : 0 Excessive deferral : 0|4
Multiple collisions : 0 Excessive collisions : 0|
Error frames : 0 
<In line error counter> 
CRC errors : 0 Symbol errors : 0|
Alignment : 0 Fragments : 0|5
Short frames : 0 Jabber : 0|
Long frames : 0 Error frames : 0
<Line fault counter> 6
Link down : 1 
<Uplink redundant> 
Switchport backup pairs Preemption Flush |7
Primary Status Secondary Status Delay Limit VLAN |
Port 0/26 Blocking Port 0/10 Forwarding 100 88 - 
>
1. Summary port information
2. Detailed port information
3. Send and receive statistics
4. Send error statistics
5. Receive error statistics
6. Failure statistics
7. Uplink redundancy statistics
Example 4
The following shows an example of displaying the 100BASE-FX/1000BASE-X interface
information, the detailed port information, and detailed statistics.
Figure 13-5 Execution result when detailed statistics for 100BASE-FX/1000BASE-X are
specified
> show interfaces gigabitethernet 0/25 detail
Date 2008/11/17 11:50:43 UTC
Port 0/25 : active up 1000BASE-LX full(auto) 00ed.f010.0131 <-1