Specifications

show interfaces
145
also used for recovery.)
 The standby link functionality of link aggregation makes the standby port the active
port.
#2: Only the PoE model displays this item.
#3: If the displayed value is smaller than 10000, the decimal point is not displayed.
If the displayed value is 10000 or larger, the unit is K and one digit is displayed below
the decimal point. If the displayed value is 10000 K or larger, the unit is M and one
digit is displayed below the decimal point.
#4: This item is always
off except when the status of the port is active up.
#5: This item is always
- except when the status of the port is active up.
#6: This item is displayed only when the command is executed with
detail specified.
#7: The frame length indicates the length starting from the MAC header and ending with the
FCS field.
For details about frame formats, see the description of frame formats in 13.1.3
Control on the MAC and LLC sublayers in the Configuration Guide Vol. 1.
#8: This item is displayed only when uplink redundancy is set in the configuration.
Example 3
The following shows an example of displaying the
1000BASE-T/100BASE-FX/1000BASE-X interface information and the detailed port
information.
Figure 13-3 Execution result when 100BASE-FX/1000BASE-X is specified
> show interfaces gigabitethernet 0/25
Date 2008/11/17 11:50:30 UTC
Port 0/25 : active up 1000BASE-LX full(auto) 00ed.f010.0131 <-1
SFP connect 
Time-since-last-status-change: 00:00:04 |
Bandwidth: 1000000kbps Average out: 0Mbps Average in: 1Mbps |
Peak out: 1Mbps at 11:49:25 Peak in: 1Mbps at 11:50:28 |
Output rate: 0bps 0pps |
Input rate: 0bps 0pps |2
Flow control send : off |
Flow control receive: off |
TPID: 8100 |
Frame size: 1518 Octets Interface name: gigaether0/25 |
Description: 
<Out octets/packets counter> <In octets/packets counter> 
Octets : 332 Octets : 5696|
All packets : 5 All packets : 89|3
Multicast packets : 3 Multicast packets : 89|
Broadcast packets : 2 Broadcast packets : 0|
Pause packets : 0 Pause packets : 0
<In line error counter> 
CRC errors : 0 Symbol errors : 0|
Fragments : 0 Short frames : 0|5
Jabber : 0 Long frames : 0|
Error frames : 0 
<Line fault counter> 6
Link down : 2 
<Uplink redundant> 
Switchport backup pairs Preemption Flush |7
Primary Status Secondary Status Delay Limit VLAN |
Port 0/25 Blocking Port 0/3 Forwarding 60 54 10 
>