Specifications

ppupdate
127
administrator mode.
Display items
None
Impact on communication
If the no-reload option is not specified, the device is automatically restarted when the
update finishes. During the restart, communication is temporarily suspended.
Response messages
Table 11-1 List of response messages for the ppupdate command
Message Description
Can't apply this image file. The specified file cannot be used because it is intended for a
different device.
Can't execute. The command could not be executed. Re-execute the
command.
Can't open (<File name>).
The specified file could not be opened. Specify the correct file
name.
Invalid file (<File name>).
The contents of the specified file are invalid. Specify a valid file.
There is not OS File.
There is no OS file (when the ramdisk <File name> parameter
is omitted).
Can't update software. [ Hardware rev.x ] Check the hardware revision number of the target device by
using the show version command.
Flash memory write failed. Writing to flash memory failed.
Notes
 When updating is performed, the configuration in effect before the update is inherited.
However, only the configuration commands that can be recognized by the new
software version can be skipped or inherited. The skipped configuration commands
are output to the operation log. For details, see 2.1 Configuration in the manual
Message Log Reference.
 Before executing the
ppupdate command, make sure the memory card is not
inserted into the Switch. If the memory card is inserted, remove it, and then execute
the
ppupdate command.