Specifications

restore

Restores the device information saved on the memory card to the Switch.

Syntax

restore mc <File name> [no-software]

Input mode

Administrator mode

Parameters

Specifies the memory card as the location where the image is stored.

Specifies the name of a file at the copy source or copy destination.

Specify the file name with 64 or fewer characters. The file name is not case sensitive.

If a file with the same name already exists at the copy destination, it will be

overwritten.

For the characters that can be specified, see Specifiable values for parameters.

no-software

No software is restored.

Operation when this parameter is omitted:

Restores all the backup data.

Example 1

Restore the device information from the file MCBackup.dat saved on the memory card.

> enable Press the Enter key.

# restore mc MCBackup.dat Press the Enter key.

Restore information from MC (MCBackup.dat).

Copy file from MC...

Restore software.

Display items

None

Impact on communication

When the device information has been restored, the device restarts automatically. During

the restart, communication is temporarily suspended.

Response messages

Table 7-9 List of response messages for the restore command

Message Description

Restore software. The restoration ended (when no-software not specified).

Restore finished. The restoration ended.