Specifications

show tech-support
89
Item Displayed information
########## <Command Name> ########## <Command Name> indicates the name of the
command executed to collect the information. The
execution result of the indicated command is displayed
after this separator.
########## End of<Command Name> ##########
A separator that indicates the end of the execution
result of the indicated command.<Command Name>
indicates the name of the command executed to
collect the information.
Impact on communication
None
Response messages
Table 7-7 Information displayed by the show tech-support command
Message Description
Can't execute. The command could not be executed. After deleting
directories and files on the RAMDISK, execute the
command again.
Can't execute for the maintenance mode. Please
remove "page" and "ramdisk" option.
The page or ramdisk option cannot be used because
the automatic restoration is disabled. Re-execute the
command without specifying those options.
Executing. Please wait a few minutes. Wait for several minutes
because the Tech-Support log is being written to the
RAMDISK.
Not enough space on device. Capacity at the write destination is insufficient.
Notes
 Before executing the show tech-support ramdisk command, make sure there are
no directories or files on the RAMDISK. If there are any directories or files on the
RAMDISK, we recommend that you delete those files before executing this
command.
 If
showtech.txt already exists on the RAMDISK, it is overwritten and saved.
 This command operates regardless of the setting of the
set terminal pager
command.
 If the automatic restoration is disabled, the collected information cannot be stored on
the RAMDISK. Also, you cannot use the
page option to display the information page
by page. In this case, use the capture function of the console terminal or another
method to check the information on the screen.