User manual

Battery Low Indicator
The battery low indicator prompts once the battery power is
down to a certain level; the following functions may be affected
or limited:
•Bluetooth connection lost and link with sensor or mobile
device failed.
•Light failed to turn on.
•Buzzer failed to sound.
In case the power low indicator persists displaying, get the battery replaced
immediately.
Replace Battery
1.Remove the four screws from your BRW's backcover with a Phillips screwdriver.
2.Release the bolt hook of the metal cover of the battery with tweezers.
3.Insert a new CR2032 battery with the positive pole facing upward.
4.Recap the metal battery cover.
5.Close the back cover and tighten the four screws.
(Note: Align the round flap at the back cover to the spring.)
1 2 3
54
• Do the basic setups described in page 12-17 after every battery replacement. If you have done
the BRW user setup with the ALA COACH+ App, you may re-sync settings to your BRW as
described in "Phone sync." on page 30-31.
Precautions for use with Runaid 10
•Due to we cannot guarantee compatibility with other manufacturer's sensors, we
sincerely recommend you use ALATECH Bluetooth sensors with your Runaid 10
BRW for activity tracking. Recommend compatible sensors as below:
ALATECH Heart Rate Strap (model CS009/CS010/CS011/CS012)
ALATECH Bluetooth 4.0 Foot Pod (model GS002BLE)
•To ensure sufficient transmission range from your heart rate strap to your
smartphone, keep your smartphone in front of you. We recommend you do not put
it in a back pocket or backpack during smartphone exercise sync.
Fail to Connect to Bluetooth Devices
•In case your Runaid 10 BRW failed to connect to a Bluetooth device, please do the
following:
1.Check battery power in your BRW and the mobile device.
2.Make sure the BRW HOT KEY is set to CONNECT PHONE. (Page 15)
3.Check whether your BRW is enabled, ALA COACH+ App>Settings>My Sensors>
Sports Watch.
4.Keep the mobile device and your BRW within 10 meters direct sight distance from
each other.
5.If the Bluetooth indicator on the device status bar turn from white to semi-transpar-
ent
, restart the mobile device, Bluetooth
®
system and ALA COACH+
App.
6.Restart the mobile device, Bluetooth
®
system and ALA COACH+ App.
7.If the problem persists, please try pairing the mobile device with other Bluetooth
device to find out the cause is caused by any of your BRW, the mobile device, or the
Bluetooth
®
system.
•If the Runaid 10 BRW failed to connect with sensors through Bluetooth, please do
the following:
1.Check battery power in your BRW and the sensor.
2.Make sure the BRW HOT KEY is set to CONNECT SENSOR. (Page 15)
34
Runaid 10, Bluetooth Running Watch (BRW)
35
User Manual
Appendix
A
Appendix
A