User's Manual
Star ONE
6
1
2
Press
Aim the charging pin
ATTENTION
During the acvity, the watch device will automacally connect to GPS and opcal heart rate
monitor, please wait the watch device display "START the mer begin workout", then start
workout to ensure get the most accurate workout data. It takes about 12~15 seconds to detect
and please remain stable to ensure accurate detecon of heart rate.
ATTENTION
The watch is shipped with low baery. Please fully
charge the device before using it.
Device charging
Please wipe charging pin with clean water and keep them dry and clean
aer the acvity to avoid corrosion. Make sure charging pin and the
surroundings are completely dry and clean before charging or connect-
ing to the computer.
1) Aim the clip-on charging to the charging pin on back of watch.
2) Make sure the non-skid foam at the inner side of charger clamp is
securely fixed.
3) Connect the USB plug of charging staon to the USB port on computer.
4) Start charging unl the baery is full.
5) Press and disconnect clip-on charging.
Start running
Please wear Star ONE on your wrist during the workout to ensure correct detection of heart rate. The built-in
optical heart rate monitor in Star ONE Watch can directly detect heart rate from the wrist, it takes about 12~15
seconds to detect and please remain stable to ensure accurate detection of heart rate.
1)
2)
3)
4)
5)
In me display (standby mode)
Click to enter quick menu, select Run/Bike with and automacally connect to GPS and opcal heart rate
monitor
. When the watch device display “START the mer to begin workout.” means GPS, opcal heart rate
monitor
and
chest heart rate monitor strap/speed/cadence sensor are completed on connecon or pairing.chest heart rate monitor
strap/speed/cadence sensor need to be paired first.
Click to start acvity. (The following are defaults.)
Click to pause mer.
• Stop: select "Save" to stop the acvity and automacally save acvity informaon. Click to check informaon.
• Resume: select "Resume" to resume acvity and connue ming.
• Discard: select "Discard" to restart acvity and recount from zero.
Under Acvity Mode, click to check acvity informaon. Hold to access workout sengs.
Run Bike