User's Manual

17
Star ONE
The acvity screen fails to start counng:
During the acvity, the watch device will automacally connect to GPS and opcal opcal heart rate monitor,
please wait the watch device display "START the mer begin workout", then start workout to ensure get the
most accurate workout data. It takes about 12~15 seconds to detect and please remain stable to ensure
accurate detecon of heart rate.
During the acvity, please wait ll watch device display “START the mer to begin workout”, then click START
key to begin workout, otherwise, the workout data will be incomplete. To begin acvity without connecon
completed, the GPS track/opcal heart rate monitor/chest heart rate monitor/speed/cadence sensor will have
incomplete workout data ; and opcal heart rate monitor may not be able to detect heart beat readings for the
whole acvity.
1)
2)
GPS:
The watch device needs to conduct global posioning in open spaces. please go to open spaces, away from tall
trees or buildings and try to receive signal from GPS again. The GPS locaon is related to the weather and the
surrounding environment.
If you do not want to acvate GPS when running, select Indoor Run under Select Acvity.t
1)
2)
Pace calibraon:
Under Run mode, when the displayed distance is not idencal to actual distance, you can click under acvity
menu and select Calibraon to manually enter the actual distance of your acvity. The watch device will recount
your pace and store the result. Recommended with stable pace running 1600M in the flat road to improve the
accuracy of step correcon.
Troubleshoong of Star ONE GPS Running Watch
Backlight is not ON:
Please confirm if the backlight is set as manual or automac mode. When the backlight is set as manual mode,
you need to click to acvate it. Refer to “Backlight seng” on P.13 for more informaon.
When you set “Stay on” in Set Time, you need to click to close the backlight. If you set “Stay on” on
backlight in acvity, the baery will goes low quickly.
1)
2)
Reset training in acvity:
Under Acvity Mode , hold and to set on/off, includes Virtual Partner, HR Zone, Training Alerts and Noficaon
. Also can set Backlight for auto or manual modes and Auto Lap funcon seng.
Incomplete data for a long-me work, in acvity, aer workout or compeon:
Make sure Virtual Partner and HR Zone are switched to ON, if you do not see Virtual Partner, HR Zone and Laps
on the acvity data screen.
If the auto lap is not automacally jumped out in workout, please make sure that the auto lap funcon is set
and turned on. If you want to manually laps, please click in workout.
When joining the compeon or doing the acvity for a long me, the watch device will remind you with the
vibraon. If the single memory is insufficient, the watch device will automacally terminate the workout record
and store integrated.
The watch device will automacally terminate the workout record and store integrated when the watch device
is running out of baery.
Before cycling acvity, it is suggested to fully charge your watch device and please synchronize data stored in
the watch device to app in advance to avoid incomplete acvity data.
Please synchronize data stored in the watch device to app immediately when you see “Memory Full” on the
screen. When you stored and the memory is full, the watch device will automacally start to overwrite the
oldest data without noficaon. When you synchronize data, if disconnecon via APP or Bluetooth occurs, may
lead to incomplete data synchronizaon, the next workout data may overwrite the unsynchronized athlec
data, if you see disconnecon, please immediately reconnect and synchronize the workout data of the watch
device.
1)
3)
4)
5)
6)
2)