User's Manual

Star ONE

Sensor Seng Hold → Seng → Sensor → Access Sengs

Hold → Seng → Bluetooth → Bluetooth

Bluetooth

1) Bluetooth: click to access sengs and click to switch to on/oﬀ.

REMINDER

The smart device can only connect to one watch. Please delete the pairing record on the app

and the watch device, and pair with your new watch if the old device is replaced by a new one

with the same part number.

Hold → Seng → Bluetooth → Noﬁcaon

Noﬁcaon

When the watch device is connected to the smart device, the smart device will forward the received message to

the watch device. You can set whether to display received message in standby mode or during acvity.

1) During Acvity: click to access Sengs and click to switch to on/oﬀ.

2) Watch Mode: click to access Sengs and click to switch to on/oﬀ.

3) Timeout: click to access Sengs and click to select the displayed second.

4) Under Acvity Mode, hold , select with and click to switch to on/oﬀ.

You can acquire more accurate acvity informaon via the chest heart rate monitor strap or speed & cadence

sensor. You can choose detecon signal from Bluetooth (BLE) or ANT+ by yourself.

Remove sensors from the watch device: Hold 　 → Seng → Sensor → Heart rate /Speed /Cadence →

Remove.

1) Mode: click to choose Bluetooth(BLE) or ANT+.

2) Heart Rate: click to detect and select status of use with .

3) Speed/Cadence: click to detect and select status of use with .

REMINDER

Please follow the above-menoned steps to wear the chest heart rate monitor correctly to

ensure the most accurate detecon during the acvity. The chest heart rate monitor is an

assisve device instead of a medical equipment. Please select the appropriate exercise

intensity according to your physical condion.

Sensors with the same funcon or part number can only be paired with one device. Please

select the previous pairing record before pairing with the new sensor.

•

Bluetooth Seng

Hold → Seng → Bluetooth → Access Sengs

You have to connect watch device with your smart device ﬁrst, if you wish to send sengs from APP to your watch

device. When the watch device is connected to the smart device,the watch device will create a PIN CODE, please

enter the PIN CODE to APP, and ﬁnish the connecon.

Unpair: Hold 　 → Seng → Bluetooth → Unpair.