Specifications
Appendix
In the other case select 0...10 V and the temperature
range O...lOO°C or
-1
00
...
400°C in the
U-INPUT.
On the display the following is shown (from top to bot-
tom):
Upper line U-INPUT the momentarily saved mode
(e.g. U-INPUT-I
:
-1
...
3V) with the channel (e.g. 1) and
the voltage range (e.g. -1
...
3V);
Lower line U-INPUT the momentarily marked mode
(e.g. U-INPUT-O:*O
...
IOV) with the channel (e.g. 0) and
the voltage range
(e.g. O...IOV);
Below:
the available modes
(e.g. 0...1 OO°C, 10 mVI0C,
-1 00
...
400°C).
With the arrow keys you can select
a mode. The
respective voltage range and channel are shown in the
lower line U-INPUT.
If
you confirm this selection (i.e.
this channel) with ENTER, the information is taken over
to the upper line U-INPUT.
I
!
1-0 STARTED
!
I
Press the menu key to get to the INPUT menu. Here
with START you can activate the defined voltage val-
ues. From now on the circulator will receive its set val-
ues via the pre-set voltage values.
For a short time in the display appears
"!
1-0
STARTED!"
together with the set values (e.g.
O...
1
OV
-+
0
...
100°C).
(
CONFII-OIANAIINISELECT
1
U-INPUT-I: -1 ..3V
!
1-0 STARTED
!
piiZZ-1
10 rnVI"C
!
If a channel is momentarily active, it is not possible
to save a new setting: while you press the ENTER
key,
"!
1-0
STARTED
!"
is shown on the display.
To save a new setting first stop the operation of the
110 plug with STOP in the INPUT or OUTPUT menu.
I
CONFII-OIANALOG
1
I-INPUT I-OUTPUT
23.3.2
Configuration of current input
If
you want to give a set value with an alalog current by
means of an external device, select I-INPUT (current
input) in the ANALOG menu and then SELECTION in
the INPUT menu to set the values for the current input.
When the SELECT menu appears two different modes
can be chosen: normal resolution (-1 00
...
400°C) and
high resolution (0
...
100°C). So with the current ranges
0...20 mA or 4...20 mA four combinations (channels 4
to
7)
are available: