Specifications
Serial
Interface
18.8
Sets of commands
For the communication there are three different sets of com-
mands. Commands of the different sets can be combined at
will.
Standard set of commands
Extended set of commands
Set of commands according to NAMUR.
#
In the following table a blank
is
represented by a
"-
",
for example "R-V1" or
"S--<value>"
0
Every command must be confirmed with
a>.
0
For all three sets of commands there is no differ-
ence between upper case and lower case letters.
1.e. there is no difference between entering "start",
"Start",
"START"
or "StArT.
0
in case of the "standard set of commands" be sure
to keep the right number of digits when entering a
value.
0
In case of the "extended set of commands" and the
"set of commands
acc. to
NAMUR",
empty places
need not be filled with
"0"
(in contrast with the
"standard set of commands").
(#
Only
with
F8/N8:
The header
"ADR"
followed the unit address must
precede every command in case of subsequent
programming (see
18.2).
E.g.
for RESET ADR07RS<cr>.
Standard set of commands:
If you have already controlled
a
circulator
DC5
via the
PC
you can use the same set of commands for the circulators of
the
F6/N6 and F8/N8 line.