Specifications

Configuration
LC0 CONTRAST VOLTAGE
IF, m, =J
On OFF
J
VERSION OSW: 1.00
ALARM CIRCUIT OK
C-ALARM CIRCUIT OK
CONTROL INTERNAI
V241R232
SELECTED
12.7 Display contrast adjustment
For contrast adjustment of the display select SETUP-2 and
then LCD-CONTR.
Change the contrast using the
(+)/(-.) keys. The value will
be shown in %, The contrast changes with a short delay.
12.8 Acoustic Signal
Select SETUP 2 and then BEEP-PG.
Whenever the
BEEP has been switched on an acoustical
message appears after the program run. This will last for one
minute.
12.9 Version numbers
For servicing or in case of product en uiries the version
%
numbers of the software or the FuzzyStar control should be
given.
Select STATUS and then VERSION. The version numbers
will be shown.
12.10 Operation status
For information about the operating status (alarm circuit of
the instrument or cooling device
(GAL...), internal or exter-
nal control and interface) please select STATUS and then
B-STATUS.