Specifications

10. Draining
The temperature control unit is drained at the nozzle.
Place a suitable vessel underneath nozzle.
0 Bear in mind that the liquid will run out in a slight arc.
Turn plug slowly until it becomes disengaged from the
thread.
A pin will prevent the liquid from running out
right away.
Pull out plug (pin) in one quick motion. The liquid will
start to run out.
Possible residues can be drained by tilting the circula-
tor slightly.
! Hot heat transfer liquid should not be drained!
When certain conditions make draining necessary,
please act safety conscious: Wear protective
clothing and protective gloves!
Option:
H
Use the liquid drain (order no. 333-0499). This push and pull
version makes emptying easier.
For assembly it is necessary to use
a fork wrench of 17 mm.
I I
Double safety against unintended opening is avoided if the
nozzle will be closed by the closing screw after use.