User manual

Model: 2100 &2300 Series
2100UM22.DOC Rev: 2.2
- 28 -
set by Relay 1 Failsafe setting).
Relay2 Hi Set Alarm Relay 2 High Setpoint: Alarm condition if
level is above this value.
40.0%
Relay2 Lo Set Alarm Relay 2 Low Setpoint: Alarm conditions
cleared if level is below this value.
35.0%
Relay2 Action Set for high or low acting (see Sections 4.3.2 –
4.3.4 for details)
High
Relay2 Failsafe Set for Failsafe or Non Failsafe Off
Relay 2 Alarm
Delay
See Relay 1 Alarm Delay description. 0 sec
Relay3 Hi Set Alarm Relay 3 High Setpoint: Alarm condition if
level is above this value.
60.0%
Relay3 Lo Set Alarm Relay 3 Low Setpoint: Alarm conditions
cleared if level is below this value.
55.0%
Relay3 Action Set for high or low acting (see Sections 4.3.2 –
4.3.4 for details)
High
Relay3 Failsafe Set for Failsafe or Non Failsafe Off
Relay4 Hi Set Alarm Relay 4 High Setpoint: Alarm condition if
level is above this value.
80.0%
Relay4 Lo Set Alarm Relay 4 Low Setpoint: Alarm conditions
cleared if level is below this value.
75.0%
Relay4 Action Set for high or low acting (see Sections 4.3.2 –
4.3.4 for details)
High
Relay4 Failsafe Set for Failsafe or Non Failsafe Off
Alarm Enable Master Alarm Relay Enable: If Off this will prevent
relays from being reflecting the Alarm condition.
The relay will remain in the non alarm condition
base on the Fail-safe switch setting on the relay
modules
ON
Filter Digital Filter response time in seconds. Used to
smooth out level fluctuations caused by splashing
etc.
0 sec
Engineering Units Eng. units chosen to display level information in
addition to the level in %.
in
Tag Number For network applications only. All Arjay 2000
series controllers connected to a network must
have a unique Tag Number between 1 and 100
1