User manual

Model: 2100 &2300 Series
2100UM22.DOC Rev: 2.2
- 27 -
6.0 CONTROLLER SETTINGS SHEET
Checked by
Model Number
Serial Number
Software Rev.
PARAMETER DESCRIPTION FACTORY
SETTING
USER
SETTING
Probe A value Probe PMC-2000 level transmitter calibration
value
Probe K value Probe PMC-2000 level transmitter calibration
value
Probe C value Probe PMC-2000 level transmitter calibration
value
Slope Result of a successful Calibration: Capacitance
change per % change. Used by unit to calculate
the level in % and Eng. Units from the measure
capacitance.
Offset Result of a successful Calibration: Calculated
capacitance of an
empty vessel. Used by unit to calculate the level
in % and Eng. Units from the measure
capacitance.
FS Value Full Scale Engineering Units value: used to
calculate Eng. Units value from level %.
100.0
Zero Zero Level value for mA output 0.0%
Span Full Scale Level value for mA output. 100.0%
mA Action Direct (20mA when level at Span) or Inverse
(4mA when level is at Span
DIR
Relay1 Hi Set Alarm Relay 1 High Setpoint: Alarm condition if
level is above this value.
20.0%
Relay1 Lo Set Alarm Relay 1 Low Setpoint: Alarm conditions
cleared if level is below this value.
15.0%
Relay1 Action Set for high or low acting (see Sections 4.3.2 –
4.3.4 for details)
High
Relay1 Failsafe Set for Failsafe or Non Failsafe Off
Relay 1 Alarm
Delay
Amount of time the level must be in an alarm
condition (based on Relay 1 High and Low
Setpoints and Action settings) before Relay 1 is
set to the alarm condition (relay alarm condition
0 sec