User manual

Model: 2100 &2300 Series
2100UM22.DOC Rev: 2.2
- 25 -
 Press the SETUP key, then 3 for Settings and then 4 for mA Trim. The unit will put out what
it thinks is 20.0mA.
 Disconnect any load connected to the mA output of the transmitter.
 With an ACCURATE MULTIMETER MEASURE THE mA OUTPUT. The Multimeter should
have at least one place of decimal.
 Enter this value at the prompt and press the Enter key. A maximum tolerance adjustment of
3% is allowed i.e. the entered value must be in the range of 19.4mA to 20.6mA. If a value out
of this range is entered an error is flashed on the screen. If this occurs, contact an Arjay
representative for assistance.
FILTER, ENGINEERING UNITS, TAG #:
These settings are described in Section 3.4.2, 3.4.3, and 3.4.4 respectively.