Installation guide

6 © 2001 Directed Electronics, Inc. Vista, CA
This wire is used in vehicles that have a positive (+) switched domelight circuit. Connect the violet wire to a
wire that shows (+)12V when any door is opened, and ground when the door is closed. This wire will report Zone 3.
Remove any paint and connect this wire to bare metal, preferably with a factory bolt rather than a screw. (Screws
tend to strip or loosen with time.) We recommend grounding all components, including the siren, to the same point.
Connect this wire to an ignition source. This input must show (+)12V with the key in run position and during
cranking. Make sure that this wire cannot be shorted to the chassis at any point. This wire will report Zone 5.
Connect this to the red wire of the siren. Connect the black wire of the siren to (-) chassis ground, preferably at
the same point you connect the control module’s black ground wire.
H1/10 BROWN (+) siren output
H1/9 YELLOW (+) ignition input, zone 5
H1/8 BLACK (-) chassis ground connection
H1/7 VIOLET (+) door trigger input, zone 3