Installation guide

4. Transmit. While HOLDING the Valet

/Program switch, press the transmitter button that you

wish to assign to that channel. The unit will chirp indicating successful programming.

5. Release. Once the code is learned, the Valet

/Program switch can be released.

You can advance from one channel to another by releasing the Valet

/Program switch and tapping it to advance

channels and then HOLDING it. For example, if you want to program Channel Three after programming Channel

One, release the Valet

/Program switch. Press it twice and release it to advance to Channel Three. Then press it once

more and HOLD it. The siren will chirp three times to confirm it is ready to receive the code from the transmitter.

One long chirp will indicate that Code Learning has been exited if any of the following occurs:

■ Ignition is turned off.

■ The doors are closed.

■ Valet

/Program switch is pressed too many times.

■ More than 15 seconds elapses between steps.

CHANNEL PRESS AND RELEASE

NUMBER THE VALET/PROGRAM SWITCH TO PROGRAM FUNCTION

1 One Time Arm/Disarm/Panic

2 Two Times Channel 2

3 Three Times Channel 3

4 Four Times Channel 4

5 Five Times Arm Only

6 Six Times Disarm Only

7 Seven Times Panic Only

8 Eight Times Auto-learn*

9 Nine Times Delete all transmitters**

*NOTE: See Transmitter Configuration section of this guide for a description of Auto-learn trans-

mitter programming.

**NOTE: If any button from a known transmitter is programmed to Channel 9, all transmitters

will be erased from memory and the system will revert to the default feature settings. (See

Features Menu section of this guide.)