Installation guide

22 © 2001 Directed Electronics, Inc. Vista, CA
plug-in LED and valet/program switch
The LED and the Valet/Program switch both plug into the control module. The LED system status indicator plugs
into the white two-pin port, while the Valet
®
/Program switch should be plugged into the blue two-pin port. The
LED and Valet
®
/Program switch each fit into
9
/32-inch holes.
LED System Status Indicator Valet
®
/Program Switch
internal programming jumper
This jumper is used to determine the light flash output. In the (+) position, the on-board relay is enabled and
the unit will output (+)12V on the H1/2 WHITE wire. In the (-) position, the on-board relay is disabled. The H1/2
WHITE wire will supply a (-) 200 mA output suitable for driving factory parking light relays. To access the jumper,
open the control module.
light flash jumper
DIA-41