Installation guide

Driver’s Door Unlock Only (Type B):

NOTE: The VIOLET jumper between the #87 lock terminal and the #87 unlock terminal must be cut

and connected to the proper polarities.

This wire supplies a (-) 200 mA output that can be used to honk the vehicle’s horn. It provides a single pulse

when armed and two pulses when disarmed. This wire also provides pulsed output when the security system is

in the triggered sequence or in panic mode. In most vehicle’s with (-) horn circuits this wire can control the

vehicle’s horn without adding a relay.

NOTE: If this output is used to drive a (+) horn circuit, an optional standard automotive SPDT relay

or a relay assembly package (p/n 8617) must be used. See the following diagram.

H3/2 BROWN/BLACK (-) 200 mA horn honk output