User manual

CFP USER MANUAL • Approved Document No. DFU7001010 Rev 1 • Page 19 of 20
CFP 2/4/8 ZONE CONVENTIONAL FIRE ALARM PANEL
BS5839-1:2002 recommends that certificates be issued for all aspects of the fire alarm system including design,
i
nstallation, commissioning, acceptance, verification (optional) and maintenance. Therefore, before this user
manual is handed over, the following installation certificate and commissioning certificate (overleaf) should be
completed as appropriate by the relevant installation/commissioning engineer(s). Please ensure that the System
Set-Up Data Chart (page 13) and the relevant parts of the Fire Alarm Log Book (page 14) are also completed as
appropriate. For countries outside the UK, different certification requirements may apply.
Certificate
of INSTALLATION
for the fire alarm system at:
Address:
I/we being the competent person(s) responsible (as indicated by my/our signatures below) for the installation of
the fire alarm system, particulars of which are set out below, CERTIFY that the said installation for which I/we
have been responsible complies to the best of my/our knowledge and belief with the specification described
below and with the recommendations of Section 4 of BS5839-1: 2002, except for the variations, if any, stated in
this certificate.
Name (in block letters):
Position (in block letters):
Signature:
Date:
For and on behalf of:
Address & postcode:
The extent of the liability of the signatory is limited to the system described below.
Extent of installation work covered by this certificate:
Specification against which the system was installed:
Variations from the specification and/or Section 4 of BS5839-1:2002 (see BS5839-1:2002, Clause 7):
Wiring has been tested in accordance with the recommendations of Clause 38 of BS5839-1: 2002.
Test results have been recorded and provided to:
Unless supplied by others, the “as fitted” drawings have been supplied to the person responsible for
commissioning the system (see Clause 36.2m) of BS5839-1: 2002: