User manual

SYSTEM SET-UP DATA CHART

Important: This page should be carefully completed by an authorised engineer prior to system hand-over.

THE INFORMATION ABOVE WAS COMPLETED BY (name) _______________________________

OF (company) _________________________________________ ON (date) __________________

(*) NOTES ON COINCIDENCE: The following applies to all pairs of zones which are set up for coincidence. There

must be alarms on both zones (i.e. zone 1 and zone 2) before the alarm sounders and outputs turn on. If only

one of the zones (i.e. zone 1) goes into alarm, the panel indicates the alarm by illuminating the relevant

indicator on the panel front and sounding its internal sounder, thus prompting the user to investigate. If found

to be false, the alarm can be reset or, if found to be a true fire condition, the sounders can be manually

activated by pressing the Silence/Activate Sounders button - as detailed on page 8.

FIRE ZONE INFORMATION

ZONE

NUMBER

ZONE DESCRIPTION

A concise explanation of the rooms and areas contained in each zone

DELAY

APPLIED?

COINCIDENCE (*)

(

tick if selected)

1 Yes/No

2 Yes/No

3 Yes/No

4 Yes/No

5 Yes/No

6 Yes/No

7 Yes/No

8 Yes/No

LENGTH OF DELAY (1 TO 10 MINUTES) IF APPLICABLE

OUTPUT ROUTING INFORMATION

TYPE OF OUTPUT CONNECTED? WHAT HAPPENS WHEN ACTIVATED?

REMOTE OUTPUT Yes/No

AUXILIARY OUTPUT Yes/No

FAULT OUTPUT Yes/No

RESET OUTPUT Yes/No

ADDITIONAL INFORMATION

Any additional Information the user needs to know should be entered in this box including repeater location,

the routing of any additional outputs, details of any inputs utilised, etc.

FP 2/4/8 ZONE CONVENTIONAL FIRE ALARM PANEL

CFP USER MANUAL • Approved Document No. DFU7001010 Rev 1 • Page 13 of 20