User manual

Notes about disablements
(a) The option of disabling or enabling zones 3 & 4 and zones 5, 6, 7 & 8 is only available if these zones
are fitted. If they are not fitted, the selection process will skip to the next available option.
(b) The option of disabling or enabling output delays is only available if delays have been programmed
into the fire alarm panel by the installation engineer. If a delay has been programmed into the
p
anel the output delays light will be lit when the panel is in the normal (i.e. non-accessed) state.
Important: Please refer to the ‘Notes on Delays’ (page 12) before proceeding to make any changes
to the way the delays function operates.
Diagram to show the disablement/enablement selection sequence
CFP 2/4/8 ZONE CONVENTIONAL FIRE ALARM PANEL
CFP USER MANUAL • Approved Document No. DFU7001010 Rev 1 • Page 11 of 20
To avoid confusion, during the selection process any light in the table of options that was showing a
fault condition will have the fault indication turned off. After the selection process is complete, fault
i
ndication will be restored unless that option was disabled during the selection process.
1
2
37
546
8
supply
present
remote
output
general
fault
power
supply
fault
system
fault
repeater
fault
sounder
status
auxiliary
output
status
output
delays
test
remote
output
status
fault
output
status
general
disablement
accessed
Zone fault/disabled/test
START (panel in accessed
state and Next Option
button pressed and held
for 3 seconds)
END
indicates option only available if
fitted or programmed