Specifications

IV
If a controller shows signs of having been damaged during
shipping, do not power up or install the controller. Save all
packing materials and report any damage to the carrier
immediately.
When the controller is powered up, the output may be activated.
Consider the effects on your process before powering up the
controller.
We recommend placing the controller in standby mode before
changing tuning parameter values manually. The output is off in
standby mode.
Do not locate this instrument where it may be subjected to
excessive shock, vibration, dirt, moisture, oil, or other liquids.
This is a Class A product. In domestic environments this product
may cause radio interference in which case the user may be
required to take adequate measures.
Specified operating ambient temperature is 32 to 131 °F
(0 to 55 °C).
Notes on CE EMC Compliance
This unit is compliant with the following standards when properly
installed into a grounded metal housing. EMC testing was
conducted with a load of 1 amp and setpoint of 400°F.
EMC directive (89/336/EEC)
EN 50081-1 (1992 edition)
EN 50082-1 (1992 edition)
Low Voltage Directive (73/23/EEC)
EN 61010-1 (1992 edition, Amendments 1, 2, 3, 4 and 11)
Caution