Installation manual

031-171-C0-003 Rev. C 27
3.0 Installation, cont.
3.2 Enclosure Installation, cont.
Installation Procedure, ‘B’ Configuration
Remove all packing material from the enclosure and inspect for damage. Continue with the
following steps:
1. Unwrap the pallet and remove the battery drawer covers. Reposition the lifting eyes to accept
cabling.
2. Position the enclosure on the pad and use as template to mark drilling locations. Ensure the pad
is smooth, level and free of bumps.
3. Remove the enclosure from the pad and drill and install pad mounting anchor bolts in accordance
with manufacturer’s instructions.
4. Place the enclosure over the pad mounting bolts and tighten the bolts to their required torque
specification.
5. Verify all cabling that passes through the riser is bundled and placed within the cutout area of the
enclosure (site dependant).
6. Replace the battery drawer covers.
Mounting Bolts